Clarke 7640130 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke 7640130에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7640130 20 페이지. Pressurised sandblaster

15. Always check to make sure that the trigger is not on before connecting

blaster to air supply.

16. Store idle tools out of the reach of children and untrained persons. Tools

may be dangerous in the hands of untrained users.

17. Drain water trap periodically during use, Do not allow moisture to fill more

than 1/2 of the water trap bowl. Do not leave water standing in water trap

when storing the sandblaster.

18. Do not allow sandblaster to sit pressurized while unattended or not in use.

19. Periodically check the abrasive medium delivery equipment. Valves, hoses

and nozzles that carry the abrasive medium after it leaves the pressure

tank are subjected to the abrasive blasting action so will wear out more

quickly than other components.

20. Release the air pressure in the tank before opening. See "Releasing

Pressure from the Tank" section, Make sure pressure gauge reads "0"

before opening the tank. Do not attempt any maintenance on the

abrasive blaster until the pressure gauge reads "0", and it has been

disconnected from the air supply.

21. Maintain correct air pressure whenever working. Do not allow pressure to

exceed 125 psi, If the safety valve does not release excess air pressure, stop

all work and release pressure from the tank (see "Releasing Pressure from

the Tank" section).

22. ALWAYS make sure there is adequate ventilation. Do not spray in confined

areas,

23. In the case of injury seek expert medical advice immediately.

24. SECURE THE WORK Use clamps or a vice to hold the work if it is small or light

weight rather than using your hands. This frees both hands to operate the

nozzle.