Clarke 7640300 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke 7640300에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7640300 13 페이지. 12v cordless tyre inflator

• For continuous inflation you can

push the switch lock upwards to

lock while the On/Off trigger is

depressed. In this way, inflation

continues without pressing any

button. To stop, simply squeeze

the trigger to release the locking

switch.

NOTE: Note that the tyre inflator has

a 10 minute running/10

minutes resting duty cycle.

• When the desired pressure is reached, the tyre inflator will stop working

as it has pre-set function. when the desired the pressure is reached,

the reading may have a +/- 1.5PSI difference. (This is normal)

8. After use, loosen the hose and remove from the tyre inflator.

WARNING: THE HOSE WILL BE HOT AFTER USE. REMOVE CAREFULLY.

WARNING: IMPROPERLY ATTACHED HOSES OR ACCESSORIES CAN

BECOME DETACHED UNDER PRESSURE AND CAUSE SERIOUS INJURY.

POSSIBLE AIR LEAKS CAN CAUSE FAULTY PRESSURE READINGS. MAKE

SURE ALL CONNECTIONS ARE TIGHTLY SECURED.

WARNING: THE GAUGE IS ONLY TO BE USED AS A REFERENCE, ALWAYS

CARRY OUT A FINAL CHECK OF THE TYRE PRESSURE WITH A GAUGE

CONFORMING TO BS EN 12645.

• When not in use, adaptors provided with the compressor can be clipped

to the storage area on the top of the compressor.

TYRE INFLATION

1. Fix the tyre valve connector onto

the vehicle tyre valve, ensuring

the valve is clean.

• When connected correctly, the

digital display will show the

current pressure in the tyre. If this is

the correct tyre pressure as stated

in your vehicle handbook, remove

the valve connector.

2. If the tyre is below the

recommended pressure (as specified in your vehicle handbook), press

either the '-' or '+' pre-set button to adjust the pre-set value on the display

to the correct tyre pressure.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]