Clarke CAT113 조립 및 사용 설명서 - 페이지 6

{카테고리_이름} Clarke CAT113에 대한 조립 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT113 13 페이지. Cut off tool

BEFORE USE

If an automatic in-line filter-regulator-lubricator is not used, the following

procedure should be carried out before use and after every two to three

hours of use.

1. Drain water from air tank, air line

and compressor.

2. Remove the plug from the rear

of the cut off tool.

3. Check and clean the air inlet

gauze filter.

4. Pour 2-3 drops of Clarke air line

oil (approx. 3 cc), into the air

inlet. This should be carried out

regardless of whether or not an air line lubricator is used.

5. Connect tool to air supply, turn ON the air supply, and check for air leaks.

If any are apparent, rectify before proceeding.

ASSEMBLY

NOTE : Ensure the airline is turned off.

1. Screw in the adaptor supplied.

2. Connect a suitable air hose to

the cut -off tool using a ¼" hose

adapter, (A whip hose with

quick fit coupling is available

from your CLARKE dealer). Then

connect the other end to the

airline.

Your cut-off tool is now ready for use.

IMPORTANT

•

NEVER use cracked or chipped cutting discs.

•

NEVER use non-reinforced cutting discs.

•

NEVER use the cut off tool without disc guard in place.

•

NEVER use the side of the cutting disc for grinding.

•

ONLY use for cutting operations.

•

ALWAYS ensure the cutting disc has stopped before putting it down.

Gauze Filter

(located here)