Clarke CHG2000C 사용자 지침 - 페이지 10

{카테고리_이름} Clarke CHG2000C에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CHG2000C 13 페이지. Hot air gun

THAWING WATER PIPES

Fit the reflector nozzle to the front of the hot air gun.

1. Always heat frozen areas inwards from the edge to the centre.

2. Take special care when defrosting plastic pipes.

3. Provide protection against heat damage to nearby paint and wall

coverings where necessary.

4. Be aware that copper gas pipes can be difficult to distinguish from copper

water pipes. Always check first.

5. Copper pipes are soldered together, therefore should not be heated

above 200

This hot air gun is maintenance free, except always ensure that the air intake

vents are kept clean. If used in a dusty environment clean the tool with low

pressure compressed air.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]