Clarke CMFT250 운영 및 유지 관리 지침 - 페이지 11

{카테고리_이름} Clarke CMFT250에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CMFT250 20 페이지. Multi function tool kit

OPERATION

1. Hold the tool firmly and switch on by

sliding the On/Off switch forward.

The motor will then run continuously.

Slide the switch back and the motor

will stop. (Fig. 1)

2. Adjust the speed control to the

desired working speed by turning

the thumb-wheel at the rear of the

machine. (Fig. 2)

3. Slowly apply the tool to the

workpiece and proceed to sand or

cut. Move the tool across the work

applying a light even pressure.

• Whether cutting, scraping or

sanding, always ensure the

workpiece is securely fixed, i.e.

clamped to a workbench or

secured in a vice.

• When working on car bodywork, the

vibration may cause any items left

on the car bonnet, boot or roof to fall, leading to injury to yourself or others

in the work vicinity. Always keep the work area tidy.

WARNING: ENSURE THAT THE WORKING POSITION ADOPTED DOES NOT

CAUSE OPERATOR FATIGUE WHICH MAY LEAD TO LOSS OF CONTROL.

USING THE SANDER ATTACHMENT

In sanding mode, the tool can be used to sand materials such as wood,

plastic, metal and painted surfaces.

WARNING: ALWAYS WEAR EYE PROTECTION AND A DUST MASK FOR

DUSTY APPLICATIONS AND WHEN SANDING OVERHEAD.

Ensure you have the correct sanding paper for the application. Always test

on scrap material before using on your final workpiece.

CHOOSING THE CORRECT SANDING SHEET

The sanding sheets are rated according to the number marked on the back

of each sheet. The lower the number, the coarser and more abrasive the

particles on the sheet will be.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

On/Off Switch

Speed control

thumbwheel

Fig. 1

Fig. 2