Clarke CMFT250 운영 및 유지 관리 지침 - 페이지 12

{카테고리_이름} Clarke CMFT250에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CMFT250 20 페이지. Multi function tool kit

Very coarse grit (e.g.40) is used for removing paint and sanding down rough

surfaces.

Medium grit (e.g.80) is used for sanding down plain timber.

Fine grit (e.g.120) is used to give a smooth finish to bare wood.

Very fine grit (400 & above) is used for fine sanding between coats of paint.

SANDING

1. Taking care that the sander is not

touching the work piece, switch

the tool on. Adjust the speed

control to the desired setting for

the task.

2. Place the tool on the workpiece,

ensuring the whole are of the

sanding base/pad is in contact

with the work surface.

3. Allow the tool to do the work and

do not apply heavy pressure.

Heavy pressure does not increase

the removal of material but may

wear out the sanding sheets

faster.

4. If sanding into corners, use the tip

or corner of the sanding pad.

NOTE: The sanding pad must be

kept flat on the workpiece.

Take care not to tilt the base

and use the edge of the pad. This will damage the sanding sheet

and pad, making it harder to grip the sanding sheet.

NOTE: Take care not to apply excessive pressure as this can cause

circular tooling marks on the work, especially if using coarse

sanding sheets.

USING THE SAW ATTACHMENTS

In sawing mode, the tool can be used to cut materials such as wood, plastics

and sheet metal such as aluminium, although the supplied blades are not

ideally suited to cutting steel or similar ferrous metals.

CAUTION: CLAMP YOUR WORKPIECE SECURELY IF POSSIBLE BEFORE

STARTING WORK.

Note: Ensure the blade is sharp and not damaged before starting work.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]