aerauliqa QR590E 설치 매뉴얼 - 페이지 9
{카테고리_이름} aerauliqa QR590E에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aerauliqa QR590E 20 페이지. Energy recovery ventilation unit with enthalpic heat exchanger
Fig. 7.b CTRL-DSP
E
DATE: shows the current date
F
MODE: shows the operation mode
G
SPEED: shows the selected speed
H
TIME: shows the time
I
FILTER ALARM: shows that filters need to be maintained/replaced
BOOST: shows that BOOST speed is activated
J
K
BOOST KEY: to manually activate the BOOST speed
L
FILTER RESET KEY: to reset the Filter Alarm
ESC key: to exit and go back to the previous menu
M
OK key: to enter the selected menu
N
O
to go DOWN with the menu selection
Some operations can be selected either from the CTRL-DSP buttons or from the menu
When powered on, the CTRL-DSP displays as follows:
Fig. 7.c CTRL-DSP operation screen
7.1 User Menu on CTRL-DSP
To enter the user menu press OK or ESC.
To exit the user menu press ESC or wait for about 60 seconds.
User menu
1 Mode Selection
2 Boost
3 Boost Duration
4 Reset FILTER Alarm
5 Night Mode
6 Installer menu
E
R
S
Q
P
O
Use or to select the menu.
Press OK to enter.
F
G
H
T
U
V
W
X
N
L
M
to go UP with the menu selection
P
Q
to power off the ventilation unit
R
shows ERROR ALARM - see point 7.3 to check the type of error
S
this symbol shows if the bypass is active
this symbol shows that ANTI-FROST is active
T
this symbol shows that the IAQ input is activated, i.e.CO2
U
this symbol shows that the HY input is activated.
V
this symbol shows that NIGHT MODE is activated
W
X
this symbol shows that Heating output is activated
I
J
K
9