Clarke CPSB100 운영 및 유지보수 지침 매뉴얼 - 페이지 7
{카테고리_이름} Clarke CPSB100에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CPSB100 20 페이지. Pressurised sandblaster
페이지 인쇄
ASSEMBLE THE FRAME
1.
Slide the axle through the axle
holes located at the bottom of the
handlebars, see Fig 3.
2. Slide a washer onto each end of
the axle.
3.
Place a wheel onto each end of
the axle then slide a washer onto
the axle.
4. Insert a split pin through the holes
in each end of the axle and bend
them so the wheels cannot slide
off the axle, see Fig 4.
ATTACH FRONT LEG
1.
Roll the tank over so that handlebars
are now facing down.
2. Align the holes of the front foot with
the holes in the foot mount on the
front side of the tank, see Fig 5.
3. Insert a split pin through the holes and
bend it so the front foot cannot
slide off the foot mount.
ATTACH THE HOSE
1.
Slide the hose onto the outlet pipe
on the bottom of the sandblaster
as shown in Fig 6.
2. Tighten the clip shown to secure
the hose.
3. Connect the sandblasting gun to
the other end of the hose, using a
suitable spanner to ensure an air
tight seal.
Fig 3
Fig 4
Fig 5
Fig 6
7