Clarke DHC-2 운영 및 유지보수 지침 매뉴얼 - 페이지 6
{카테고리_이름} Clarke DHC-2에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke DHC-2 9 페이지. Double headed metal nibbler
페이지 인쇄
OPERATION
•
Apply the metal nibbler to the workpiece only when
running at full speed.
•
Always hold the
metal nibbler
vertical to the
surface of the steel
sheet and without
tilting. The cut takes
place during the
upward motion of
the metal nibbler.
•
Guide the metal nibbler evenly and with moderate
feed pressure in the cutting direction.
•
Do not exert force, otherwise the metal nibbler and
cutter guide will become damaged.
USING THE METAL NIBBLER
•
Straight cuts are carried out best when the metal
nibbler is guided alongside a ruler/straight edge.
•
Contours can be cut by guiding the metal nibbler along
a curved template.
•
For inside cuts, you will need to pre-drill a 10 mm hole.
CHANGING THE CUTTER GUIDE
1.
Remove cutter guide fixing
screws using the hex key.
2.
Pull the cutter guide away
from the main body.
3.
Replace the cutter guide
with a new one and tighten
the fixing screw to secure.
6
Fig. 4
Fig. 5