Clarke ECSS2 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke ECSS2에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke ECSS2 18 페이지.

BEFORE USE / SETUP

WARNING: MAKE SURE THE SHARPENER IS NOT CONNECTED TO THE

MAINS SUPPLY DURING SETUP.

1. Clean the chain before sharpening. Wash it with a non-flammable solvent.

Do not use petrol. Dry the chain.

2. Lift up the chain stop and place

the chain in the sliding guide as

shown.

• Look at each tooth on the

chain and start with the most

worn tooth. Position this tooth

roughly in the centre of the

sliding guides. All other teeth will

be ground to the same depth.

3. Loosen the locking wheel to allow

the chain holder assembly to turn.

4. Check with your chain

manufacturer to determine the

angle you need.

5. Rotate the chain holder assembly

to the angle required.

6. Tighten the locking wheel.

• Do not rotate the chain holder

assembly when the grinding disc is moving.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]