Clarke ECSS2 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke ECSS2에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke ECSS2 18 페이지.

LIMITING THE DEPTH OF CUT

7. Lower the top housing so that the

grinding wheel skims the chain

tooth.

8. Hold it at that position while you

tighten the depth limiter until it

touches the stop on the base.

• The grinding wheel will only go

down to that point from now

on.

9. Tighten the depth limiter locking

screw against the main body to secure.

10. Depending on the amount of

material you wish to remove,

tighten or loosen the Lock Knob

and adjust the chain stop

adjustment screw.

• This will determine how much

material is removed. Once you

set the chain stop adjustment

screw, fully tighten the lock

knob.

11. Lower the chain stop so that it drops behind the tooth that you want to

start with.

FINALLY

12. Lock the chain in the sliding guide

by turning the handle clockwise.

The handle should be positioned

so that you can easily release and

tighten it.

• You will need to release it each

time you move to the next

tooth, and tighten it to sharpen

each tooth.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]