ALE Coral 144 운영자 매뉴얼 - 페이지 13

{카테고리_이름} ALE Coral 144에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALE Coral 144 18 페이지.

ALE

Fitting a bottle of ink into the reservoir:

●

Using a craft knife (or a sharp blade), cut the round raised plastic dome on the top of

the ink bottle cap (Fig. 14). Turn the bottle up-side down and push into the reservoir

(Fig. 15).

Fig. 14: Cutting the plastic cap of the ink bottle

Switch the controller on. From this moment, the LCD screen will run through the

●

start up procedure. The controller is ready when the red LED goes off. The default

language is English on all new machines. To change the language, please report to

the controller's user manual.

The controller needs to be adjusted to the print-head. To do this, the Setup Wizard

●

is used. It can be accessed from the controller's main screen (Fig. 16). Follow the

steps of the Setup Wizard for basic configuration. Please report to the controller's

user manual for more information.

Then the ink system needs to be purged of air.

Coral144 Operator Manual

Design • Print • Trace

Fig. 16: MasterPad main screen : access to setup

Fig. 15: fitting a bottle

wizard

03/12/2010