ALE Coral 144 운영자 매뉴얼 - 페이지 8

{카테고리_이름} ALE Coral 144에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALE Coral 144 18 페이지.

ALE

Fig. 7: Coral 144 bottom dimensions with M5 mounting points

1.4

Alarm LEDs

There are eight red alarm LEDs on top of the print-head. Each one corresponds to an

ink bottle (See 1.2 for numbering). It starts blinking when the level of ink is too low in

the corresponding reservoir, which means that the bottle of ink is empty. Replace it by

following the steps described in

After a configured number of prints, if the ink level is still low in the reservoir, the

controller stops the printing (to avoid defective printings). See the controller manual for

information on configuring the number of prints after the ink-low signal.

When the ink low is detected, the print-head sends an alarm signal to the controller,

which can transfer it to an external device such as a PLC. See controller manual for

details.

2.1

Coral144 Operator Manual

Design • Print • Trace

3.1.Ink bottle replacement

03/12/2010