Clarke STRONG-ARM CSA20EP 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke STRONG-ARM CSA20EP에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke STRONG-ARM CSA20EP 17 페이지. 20 tonne hydraulic press

PREPARATION

1. Before using the press, purge any

air from the jack by using the

crimped end of the handle to

open the release valve (turning it

anti-clockwise) and pumping the

jack several full strokes to

eliminate any air bubbles.

2. Check all parts are secure and

correctly aligned before using the

press.

POSITIONING THE BED

Due to the weight of the bed, we recommend that you get assistance from

another person when changing the bed height.

1. Raise one side of the bed and insert a supporting pin into the next locating

hole.

2. Repeat at the other end to level the bed..

CAUTION: IT IS SAFER AND EASIER IF THE BED HEIGHT IS ONLY RAISED OR

LOWERED ONE HOLE AT A TIME, WORKING ALTERNATELY FROM ONE

SIDE AND THEN THE OTHER UNLESS AN ASSISTANT IS AVAILABLE TO

SUPPORT THE WEIGHT OF THE BED WHILE THE PINS ARE INSERTED.

3. Position the bed at the desired height, so that it will be as close as possible

to the ram when the workpiece is mounted on it.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]