Clarke STRONG-ARM CSA20EP Manuale di istruzioni per il funzionamento e la manutenzione - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per il funzionamento e la manutenzione per Utensile elettrico Clarke STRONG-ARM CSA20EP. Clarke STRONG-ARM CSA20EP 17. 20 tonne hydraulic press
Stampa la pagina
PREPARATION
1. Before using the press, purge any
air from the jack by using the
crimped end of the handle to
open the release valve (turning it
anti-clockwise) and pumping the
jack several full strokes to
eliminate any air bubbles.
2. Check all parts are secure and
correctly aligned before using the
press.
POSITIONING THE BED
Due to the weight of the bed, we recommend that you get assistance from
another person when changing the bed height.
1. Raise one side of the bed and insert a supporting pin into the next locating
hole.
2. Repeat at the other end to level the bed..
CAUTION: IT IS SAFER AND EASIER IF THE BED HEIGHT IS ONLY RAISED OR
LOWERED ONE HOLE AT A TIME, WORKING ALTERNATELY FROM ONE
SIDE AND THEN THE OTHER UNLESS AN ASSISTANT IS AVAILABLE TO
SUPPORT THE WEIGHT OF THE BED WHILE THE PINS ARE INSERTED.
3. Position the bed at the desired height, so that it will be as close as possible
to the ram when the workpiece is mounted on it.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7