Clarke Woodworker CPT800 운영 및 유지보수 매뉴얼 - 페이지 7

{카테고리_이름} Clarke Woodworker CPT800에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CPT800 18 페이지. Planer/thicknesser
Clarke Woodworker CPT800에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (18 페이지)

페이지 인쇄

UNPACKING and PARTS IDENTIFICATION

Carefully unpack the components and lay them out, checking against the

following list. Should any part be missing or damaged in transit, please contact

your Clarke dealer immediately.

NOTE:

Dust extraction

devices

are

available

from

your Clarke dealer

ASSEMBLY and INSTALLATION

Ensure the planer is located where there is adequate light, and a suitable power

supply. If cable a extension is used, ensure it does not trail along the workshop

floor as this could be extremely hazarous.

There must be sufficient room for the workpiece to move through its entire length.

Similarly, there must be sufficient room so that the operator does NOT need to

stand in line with the wood during the planing process.

The planer may be used as a mobile unit, but for greater stability we recommend

it is bolted to a strong, firm workbench. The dimensions for the mounting holes are

shown below:

Alternatively, mount the planer on a

strong piece of plywood of at least

15mm in thickness, with length

550mm and width 380mm minimum.

The plywood platform, with planer

mounted, is then clamped firmly to a

workbench when required.

Fig. 2

Fig. 1