Zanussi ZRB934PW 사용자 설명서 - 페이지 7

{카테고리_이름} Zanussi ZRB934PW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZRB934PW 12 페이지. Zanussi refrigerator user manual

페이지 인쇄

1. Technical Data

Installation

Caution! Read the "Safety Information" carefully

for your safety and correct operation of the

appliance before installing the appliance.

Positioning

Install this appliance at a location where the ambient tem-

perature corresponds to the climate class indicated on

the rating plate of the appliance:

Climate

class

+10°C to + 32°C

+16°C to + 32°C

+16°C to + 38°C

+16°C to + 43°C

Location

The appliance should be installed well away from sour-

ces of heat such as radiators, boilers, direct sunlight

etc. Ensure that air can circulate freely around the back

of the cabinet. To ensure best performance, if the appli-

ance is positioned below an overhanging wall unit, the

minimum distance between the top of the cabinet and

the wall unit must be at least 100 mm . Ideally, howev-

er, the appliance should not be positioned below over-

hanging wall units. Accurate levelling is ensured by one

or more adjustable feet at the base of the cabinet.

Warning! It must be possible to disconnect the

appliance from the mains power supply; the plug

must therefore be easily accessible after installation.

Electrical Connection

Caution! Any electrical work required to install

this appliance should be carried out by a qualified

electrician or competent person.

Ambient temperature

Warning! This appliance must be earthed.

The manufacturer declines any liability should

these safety measures not be observed.

Important! The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow:

Brown:

Blue:

As the colours of the wires in the mains lead of this ap-

pliance may not correspond with the coloured markings

identifying the terminals in your plug, proceed as follows:

1. Connect the wire coloured green and yellow to the

terminal marked either with the letter "E" or by the

earth symbol

or coloured green and yellow.

2. Connect the wire coloured blue to the terminal ei-

ther marked with the letter "N" or coloured black.

3. Connect the wire coloured brown to the terminal ei-

ther marked with the "L" or coloured red.

4. Check that no cut, or stray strands of wire is

present and the cord clamp

outer sheath.

5. Make sure the electricity supply voltage is the same

as that indicated on the appliance rating plate.

6. Switch on the appliance.

Earth

Live

Neutral

is secure over the