Zanussi Hobs 운영 및 설치 매뉴얼 - 페이지 7

{카테고리_이름} Zanussi Hobs에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi Hobs 15 페이지. Gas hobs
Zanussi Hobs에 대해서도 마찬가지입니다: 지침 책자 (12 페이지), 운영 및 설치 매뉴얼 (7 페이지), 지침 책자 (16 페이지)

페이지 인쇄

CONNECTION TO THE GAS SUPPLY

Gas connection must be carried out in conformity

with the regulations in force. The appliance

leaves the factory tested and regulated for the

type of gas indicated on the plate which is

situated in the lower position near the gas

connection tube. Ascertain that the type of gas

with which the appliance will be supplied is the

same as that indicated on the plate.

If different carry out all the operations according

to the indications cited in the paragraph "adaption

to different types of gas".

For a maximum output and minimum

consumption ascertain that the pressure of the gas

used has the values indicated in the table of

"burner characteristics".

If the pressure of the gas used is different (or

variable) from that foreseen it is necessary to

install a suitable pressure regulator on the inlet

tube.

The use of pressure regulators for liquid gas

(GPL) is permitted as long as these conform to

the regulations in force.

The joint is mounted on the intake area of the

pipe, fitted with a filleted nut GJ 1/2, between the

sealing components as shown in Fig. 1. Screw the

parts without forcing, turn the joint in the

direction required and then tighten everything.

A) Intake pipe with nut

B) Seal

C) Adjustable joint

CONNECTION

Carry out the connection to the gas plant only by

means of a rigid metallic tube conforming to the

regulations in force.

The joint for the entry of gas into the appliance is

threaded GJ 1/2".

Carry out the connection avoiding any type of

stress on the appliance.

The adjustable joint permits the location of the

supply tube in the appropriate site situated on the

side of the protection box of the hob itself (Fig.

2).

This system permits the total encumbrance of the

hob plus the gas supply tube to be contained to a

depth of 30 mm.

A) Intake pipe with nut

B) Adjustable joint

C) Rigid metallic gas supply tube

FO 0265

IMPORTANT

Upon completion of installation, always check:

that all the joints are completely sealed by

using a soapy solution, never a flame;

that the automatic ignition system is

Fig. 1

operating satisfactory on all burners, both

individually and in combination.

Fig. 2