Zanussi Hobs 운영 및 설치 매뉴얼 - 페이지 8

{카테고리_이름} Zanussi Hobs에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi Hobs 15 페이지. Gas hobs
Zanussi Hobs에 대해서도 마찬가지입니다: 지침 책자 (12 페이지), 운영 및 설치 매뉴얼 (7 페이지), 지침 책자 (16 페이지)

페이지 인쇄

ELECTRICAL

CONNECTION

The appliance is predisposed to function with a

230V monophase voltage tension. Connection

must be carried out in conformity with the

regulations and dispositions of the laws in force.

Before connecting ensure that:

- The limiter valve and the electrical mains can

support the voltage of the appliance (see

registration plate).

- The power supply is correctly earthed according

to the regulations in force.

- The plug or omnipolar interrupter used can be

easily reached once the appliance has been

installed.

Fit the cable with a plug suitable to the voltage

and connect to an appropriate security socket.

If a direct connection to the mains is required, an

omnipolar interrupter with a minimum opening of

3mm between contacts, dimensioned to the

voltage and corresponding to the regulations in

force, should be interposed between the appliance

and the supply. The yellow/green earth cable must

not be interrupted by the interrupter. The brown

coloured phase cable (situated at terminal "L" of

the terminal box) must always be connected to the

network phase. The voltage cable must always be

positioned in such a manner that it at no point

reaches a temperature of 50 C above room

temperature. An example of the best routing is

shown in fig. 3. The cable is guided by use of

clamps fixed laterally to the unit in such a way as

to avoid any contact with the appliance under the

hob.

FO 0073-EN

Fig. 4

YES

CLAMPS

Openings

{

in the

Forniture

Unit

REAR VIEW

FO 0238-EN

In case of substitution of the voltage cable use

cable type H05 RRF having a section suited to the

charge, it is furthermore necessary that the

yellow/green earth wire be approximately 2cm

longer than the phase and neutral wires (Fig. 4).

After connection try out the heating elements

allowing them to function for approximately 3

minutes.

The manufacturer declines all responsibility

in case the prevention of accidents regulations

are not respected.

RIGID METALLIC TUBE

OR FLEXIBLE STAINLESS

STEEL TUBE

Fig. 3