Zanussi ZGF 759 지침 책자 - 페이지 10
{카테고리_이름} Zanussi ZGF 759에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 759 14 페이지. Gas hob
페이지 인쇄
Building In
Building over a cupboard or drawer
If the hob is to be installed above a cupboard or
drawer it will be necessary to fit a heat resistant board
below the base of the hob on the underside of the
work surface.
Building over a kitchen unit with door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the
bottom of the hob which can be heated when it is
operated. The recommended solution is shown in
diagram 1.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.
a
60
b
FO 2044
a) Removable panel
b) Room for connections
1
480
FO 2043
FO 2041
Building over a kitchen unit with oven
If the hob is built into a kitchen unit with an oven
underneath, the recess must have the dimensions
shown in diagrams 2 and 3, and should also incorpo-
rate suitable oven crosspiece supports to ansure an
efficient cooling air circulation.
Diagrams 4 and 5 give two building-in examples.
The electric connection of the hob and the
oven should be carried out separately, for
electrical safety reasons to permit easy
extraction of the oven from the front part of
the kitchen unit.
2
380
140
4
2
50 cm
2
360 cm
550 min.
FO 0198
180 cm
FO 2042
3
5
2
120 cm
2
11