Zanussi ZGF 782 지침 책자 - 페이지 12

{카테고리_이름} Zanussi ZGF 782에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 782 19 페이지. Hob zanussi
Zanussi ZGF 782에 대해서도 마찬가지입니다: 지침 책자 (20 페이지), 지침 책자 (19 페이지), 지침 책자 (20 페이지), 지침 책자 (20 페이지), 지침 책자 (19 페이지)

페이지 인쇄

Building In

Building over a cupboard or drawer

If the hob is to be installed above a cupboard or

drawer it will be necessary to fit a heat resistant board

below the base of the hob on the underside of the

work surface.

ON/OFF SWITCH

FLEX

OUTLET

FO 0763

Building over a kitchen unit with door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the

bottom of the hob which can be heated when it is

operated. The recommended solution is shown in

diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

• put the seals supplied with the hob, on the

edges of the cut out: place them exactly on

the front and rear edge and at 50 mm. from

the side edges, as shown in the diagram, taking

care that the seals meet without overlapping;

• place the hob in the cut out, taking care that it

is centred;

• fix the hob with the relevant fixing clamps

and screws, as shown in the diagram. When

the screws have been tightened, the excess

seal can be removed.

The edge of the hob forms a double seal which

prevents the ingress of liquids.

It is also recommended to carry out the electrical

connection to the hob as shown in diagrams 1 and 2.

ON/OFF SWITCH

FLEX

OUTLET

FO 0764

FO 2039

FO 0199

FO 1013

Dimensions are given in mm.

Seal