Zanussi ZGG 659 지침 책자 - 페이지 5

{카테고리_이름} Zanussi ZGG 659에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG 659 11 페이지. Zanussi cooktop user manual

페이지 인쇄

Operation

Hob burners control knobs

The symbols on the hob burners control knobs

mean that:

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before

putting a pan on the pan support.

To light a burner:

Push in the relevant knob and turn it

anticlockwise to "maximum position".

At the same time, keep the knob pushed

down for about 5 seconds. This will allow the

"thermocouple" (Fig. 1, lett. C) to be heated

and the safety device to be switched off,

otherwise the gas supply would be interrupted.

Then, check the flame is regular and adjust it

as required.

If you cannot light the flame even after several

attempts, check the "cap" (Fig. 1, lett. A) is in the

correct position.

To put the flame out, turn the knob to the symbol

When switching on the mains, after

installation or a power cut, it is quite normal

for the spark generator to be activated

automatically.

Always turn the flame down or put it out

before taking the pans off the burner.

Using the hob correctly

To ensure maximum burner efficiency, it is strongly

recommended that you use only pots and pans

with a bottom fitting the size of the burner used, so

that flame will not spread beyond the bottom of the

vessel (See table).

Burner

Large (rapid)

Medium (semi-rapid)

Small (Auxiliary)

minimum

maximum

diameter

160 mm

240 mm

120 mm

220 mm

80 mm

160 mm

FO 2295

Fig. 1

A - Burner cap

B - Ignition candle

C - Thermocouple

If you use a saucepan which is smaller

than the recommended size, the flame will

spread beyond the bottom of the vessel,

causing the handle to overheat.

As soon as a liquid starts boiling, turn

down the flame so that it will barely keep

the liquid simmering.

Take care when frying food in hot oil or

fat, as the overheated splashes could

easily ignite.

If the control knobs become difficult to

turn, please contact your local Service

Centre.