Zanussi ZGG35214 사용자 설명서 - 페이지 6

{카테고리_이름} Zanussi ZGG35214에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG35214 16 페이지.
Zanussi ZGG35214에 대해서도 마찬가지입니다: 사용자 설명서 (28 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (20 페이지)

페이지 인쇄

4. With a thin screwdriver, adjust the by-pass

screw position.

The by-pass screw

– If you change from natural gas G20 20

mbar to liquid gas, fully tighten the ad-

justment screw in.

– If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn.

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Electrical connection

• The electrical work necessary to install the

appliance must be done by a qualified elec-

trician or competent person, according to the

current regulations.

• The appliance must be earthed.

• Always use a correctly installed shockproof

socket.

• Make sure that there is access to the mains

plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• The appliance must not be connected with

an extension cable, an adapter or a multiple

socket. There is a risk of fire. Make sure that

the ground connection complies with the

standards and regulations force.

• The power cable must not touch any hot

parts.

• The electrical installation must have an isola-

tion device which lets you disconnect the ap-

pliance from the mains at all poles. The isola-

tion device must have a contact opening

width of minimum 3 mm.

• You must have the correct isolation devices:

line protecting cut-outs, fuses (screw type

fuses removed from the holder), earth leak-

age trips and contactors.

• The connection cable parts must not be

heated to a temperature above 90°C.

Electrical Requirements

Permanent electrical installation must comply

with the latest I.E.E. Regulations and local Elec-

tricity Board regulations. For your own safety

the installation must be done by a qualified

electrician (e.g. your local Electricity Board, or a

contractor who is on the roll of the National In-

spection Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer declines any liability if

these safety measures are not observed.

The appliance must be connected to a 230 V

50 Hz AC electrical supply.

Before activating the appliance, make sure the

electrical supply voltage is the same as that in-

dicated on the rating plate. The rating plate is

located on the bottom of the appliance.

The appliance is supplied with a 3 core flexible

supply cord requiring a 3 amp plug.

You must obtain and install the plug. The wires

in the mains lead are coloured in accordance

with the following code:

Green and yellow

Blue

Brown

1. Connect the green and yellow (earth) wire

to the terminal in the plug which is marked

with the letter 'E' or the earth symbol

or coloured green and yellow.

2. Connect the blue (neutral) wire to the ter-

minal in the plug which is marked with the

letter 'N' or coloured black.

3. Connect the brown (live) wire to the termi-

nal in the plug which is marked with the let-

ter 'L' or coloured red.

- Earth

- Neutral

- Live