Zanussi ZKT 621 LX 작동 및 설치 지침 - 페이지 18

{카테고리_이름} Zanussi ZKT 621 LX에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZKT 621 LX 22 페이지. Elektric ceramic glass hob
Zanussi ZKT 621 LX에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (18 페이지)

페이지 인쇄

Installation instructions

Hints on safety

This appliance must be installed and connec-

ted by qualified personel. Please observe this

instruction, otherwise the warranty will not

cover any dmage which may occur.

During the installation and in case of a service fai-

lure the appliance must not be connected to the

mains.

The general rules for the operation of electric ap-

pliances, the provisions by the competent electri-

city supply board and the specifications of these

instructions for installation have to be strictly ad-

hered to.

Built- -in in the kitchen worktop

Electrical safety is to be ensured by professional

installation.

Protection against accidental contact according

to the regulations set by VDE or other local autho-

rities must be ensured by correct installation of

the appliances. The same refers to the back of the

appliance which, even in case of built--in solutions

away from the wall, must not be freely accessible.

Built--in cupboards have to be located and faste-

ned in a way that they are stable.

Note down the data from the rating plate of your

appliance in the printed rating plate form in this

manual. These numbers are needed in case of

service calls.

Installation dimensions

The opening in the cabinet must correspond to the

standard dimensions. The necessary information can

be found in the dimensional sketch.

The separation between the lower surface of the

hob and the parts of the furniture below it must be

at least 20 mm

The lateral separation between the sides of the

hob and the cabinet must be at least 55 mm, and

must be at least 55 mm from the rear panel.

distance from worktop

opening to the rear wall

55 mm

20 mm

distance from worktop opening to

the left or right side wall or to a

high cupboard

50 mm

20 mm