Zanussi ZRB934PW2 사용자 설명서 - 페이지 10
{카테고리_이름} Zanussi ZRB934PW2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZRB934PW2 28 페이지. Fridge freezer
페이지 인쇄
If your appliance is still not working properly after making
the above checks, contact the After Sales Centre.
Replacing the lamp
1.
Disconnect the appliance.
2.
Push the movable part to unhook the lamp cover (1).
3.
Remove the lamp cover (2).
4.
If needed replace the lamp with a light of similar
characteristic and power. It is suggested to use Os-
ram PARATHOM SPECIAL T26 0.8 Watts.
5.
Install the lamp cover.
6.
Connect the appliance.
7.
Open the door. Make sure that the lamp comes on.
Technical data
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.
Installation
Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
10
Downloaded from Fridge-Manual.com Manuals
1
Closing the door
1.
2.
3.
Height
Width
Depth
Climate
SN
N
ST
T
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
2
Clean the door gaskets.
If necessary, adjust the door. Refer to "Installation".
If necessary, replace the defective door gaskets.
Contact the Service Center.
1750 mm
595 mm
658 mm
20 h
230-240 V
50 Hz
Ambient temperature
class
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
www.zanussi.com