Zanussi ZRB934PW2 사용자 설명서 - 페이지 8

{카테고리_이름} Zanussi ZRB934PW2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZRB934PW2 28 페이지. Fridge freezer

페이지 인쇄

Defrosting of the refrigerator

Frost is automatically eliminated from the evaporator of

the refrigerator compartment every time the motor com-

pressor stops, during normal use. The defrost water

drains out through a trough into a special container at the

back of the appliance, over the motor compressor, where

it evaporates.

It is important to periodically clean the defrost water drain

hole in the middle of the refrigerator compartment channel

to prevent the water overflowing and dripping onto the

food inside. Use the special cleaner provided, which you

will find already inserted into the drain hole.

Defrosting the freezer

A certain amount of frost will always form on the freezer

shelves and around the top compartment.

Defrost the freezer when the frost layer reaches a thickness

of about 3-5 mm.

To remove the frost, follow the instructions below:

• pull out the plug from the wall socket or switch off the

appliance

• remove any stored food, wrap it in several layers of

newspaper and put it in a cool place

• remove the freezer drawers

Troubleshooting

Caution! Before troubleshooting, disconnect the

power supply.

Only a qualified electrician or competent person must do

the troubleshooting that is not in this manual.

Problem

The appliance is noisy.

The compressor operates contin-

ually.

Downloaded from Fridge-Manual.com Manuals

Possible cause

The appliance is not supported prop-

erly.

The Temperature regulator may be set

incorrectly.

The door is not closed correctly.

• put insulating material around the drawers, e.g. blan-

kets or newspapers.

Defrosting can be accelerated by placing bowls with hot

water (not boiling) inside the freezer.

• Loosen the drainage channel from its resting position,

push it in according to the illustration and place it in

the bottom freezer drawer where water can collect

• carefully scrape off the ice when it starts to thaw. Use a

wood or a plastic scraper

• when all the ice has melted, clean and wipe the cabinet

dry, then put the drainage channel back in place.

• switch on the cabinet and replace the frozen foodstuff.

It is recommended to operate the appliance at the highest

position of the thermostatic control for some hours so that

it can reach the sufficient storing temperature as soon as

possible.

Important! Never use sharp metal tools to scrape off frost

from the evaporator as you could damage it. Do not use a

mechanical device or any artificial means to speed up the

thawing process other than those recommended by the

manufacturer. A temperature rise of the frozen food packs,

during defrosting, may shorten their safe storage life.

Important! There are some sounds during normal use

(compressor, refrigerant circulation).

Check if the appliance stands stable (all

the four feet should be on the floor).

Set a warmer temperature.

Refer to "Closing the door".

Solution