Zanussi ZHC960 지침 책자 - 페이지 13

{카테고리_이름} Zanussi ZHC960에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZHC960 17 페이지. Zanussi owners manual ventilation hood zhc960
Zanussi ZHC960에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

Zanussi ZHC960 지침 책자
Fitting the Wall Brackets
Draw a vertical line on the wall, from the
centre of the cooking appliance up to the
ceiling, or as high as is practical using a
spirit level and marker pen. This is to
ensure the correct vertical alignment of
the product.
Draw a horizontal line through the vertical
at 650mm above the hob.
Place the first bracket item 7.2 against
the wall 1 or 2mm from the ceiling or the
upper limit as shown aligning the notch in
the centre with the vertical line and mark
the hole centres on the wall ready for
drilling.
Place the second bracket item 7.2 against
the wall at X below the first bracket as
shown aligning the notch in the centre with
the vertical line and mark the hole centres
on the wall ready for drilling. (X is
determined by the height of the upper
chimney supplied).
Draw a horizontal line through the vertical
at 323mm above the hob and mark two
hole centres at 116mm either side of the
vertical line.
Drill the six holes for the fixing screws and
rawl plugs (not supplied).
Fix the two wall brackets using the top four
screw holes as illustrated.
Insert two screws into the holes 116mm
either side of the vertical and tighten the
screws leaving a space between the
underside of the screwhead and the wall
of 5-6mm.
Note: If the hood is to be installed onto a
hollow construction or plaster or partition
board wall then the special fixing screws
will be required (not supplied).
Fitting the Hood Body
Before starting to fix the hood body,
tighten the two screws item Vr located on
the top of the hood body.
Hook the hood body on to the screws
116mm either side of the vertical line and
fully tighten the screws 12a (not supplied).
Using a screw driver and spirit level,
adjust the screws item Vr until the hood
body is level.

INSTALLING THE COOKER HOOD

Page 13