Zanussi ZHC960 Talimat Kitapçığı - Sayfa 13
Havalandırma Davlumbazı Zanussi ZHC960 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZHC960 17 sayfaları. Zanussi owners manual ventilation hood zhc960
Ayrıca Zanussi ZHC960 için: Kullanım Talimatları Kılavuzu (13 sayfalar)
Fitting the Wall Brackets
Draw a vertical line on the wall, from the
•
centre of the cooking appliance up to the
ceiling, or as high as is practical using a
spirit level and marker pen. This is to
ensure the correct vertical alignment of
the product.
Draw a horizontal line through the vertical
•
at 650mm above the hob.
Place the first bracket item 7.2 against
•
the wall 1 or 2mm from the ceiling or the
upper limit as shown aligning the notch in
the centre with the vertical line and mark
the hole centres on the wall ready for
drilling.
Place the second bracket item 7.2 against
•
the wall at X below the first bracket as
shown aligning the notch in the centre with
the vertical line and mark the hole centres
on the wall ready for drilling. (X is
determined by the height of the upper
chimney supplied).
Draw a horizontal line through the vertical
•
at 323mm above the hob and mark two
hole centres at 116mm either side of the
vertical line.
Drill the six holes for the fixing screws and
•
rawl plugs (not supplied).
Fix the two wall brackets using the top four
•
screw holes as illustrated.
Insert two screws into the holes 116mm
•
either side of the vertical and tighten the
screws leaving a space between the
underside of the screwhead and the wall
of 5-6mm.
Note: If the hood is to be installed onto a
hollow construction or plaster or partition
board wall then the special fixing screws
will be required (not supplied).
Fitting the Hood Body
Before starting to fix the hood body,
•
tighten the two screws item Vr located on
the top of the hood body.
Hook the hood body on to the screws
•
116mm either side of the vertical line and
fully tighten the screws 12a (not supplied).
Using a screw driver and spirit level,
•
adjust the screws item Vr until the hood
body is level.
INSTALLING THE COOKER HOOD
Page 13