Zanussi ZCG7680 사용자 설명서 - 페이지 41

{카테고리_이름} Zanussi ZCG7680에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZCG7680 44 페이지. Zanussi user manual gas cooktop zcg7680, zcg7690
Zanussi ZCG7680에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지)

페이지 인쇄

4. Assemble upper bracket to lower bracket

so that the underside of bracket is

dimension ' C' + 3mm above floor level.

(See Fig. 3b)

Reposition appliance and check that top

bracket engages into appliance back as

shown in Fig. 3b.

Pressure testing

The oven injector is used as a pressure

test point.

Remove the oven furniture. Remove

oven burner box retaining clips (one

spring clip from each side) and remove

box front cover. Replace one clip back

into the right hand side of the burner

box.

Remove oven burner by removing the

spring clip from the right hand side of

the oven burner and slide burner off

injector, whilst easing it forward and

taking care not to strain the F.S.D.

phial.

Connect the pressure gauge to the

oven injector.

Check the supply pressure by turning

the thermostat on and one hotplate tap

full on and light the appropriate burner.

The pressure should be either:-

(i)

For Natural Gas 20mbar

(ii)

For LP. Gas. The pressure must

be set to 28 mbar for use on

butane or 37 mbar for use on

propane.

4. Turn off the taps, disconnect the

pressure gauge and replace oven burner

and cover, ensuring that the F.S.D phial

is correctly located into the bracket on

the burner.

5. Check operation of the oven.

Checking the grill

Place the grill pan containing the grid, with

the

handle

attached,

compartment.

Light the grill burner by

turning the grill tap full on and pressing the

ignition button on the fascia panel. As soon

as the burner is lit the button can be

released.

Checking the hotplate

Lift the lid. Fit the burner crowns and caps

ensuring that they are correctly seated. Fit

the pan supports.

Check each of the hotplate burners in turn

by turning the hotplate tap to its full on

position and pressing the ignition button. As

soon as the burners are lit the button can be

released.

Checking the second oven

Turn the second oven thermostat

control knob to Mk.1 and press the

ignition button. As soon as the burner

is alight the button can be released.

When the oven burner lights up there

should be a low gas rate at first to the

oven burner which is the F.S.D. bypass

rate.

When the F.S.D. phial has heated up it

opens the F.S.D. valve and the main

gas stream flows to the burner.

After 1 minute check that the flame

covers the full width of the burner and is

stable.

Set the oven control to Mk. 2, close the

oven door and check that after about 10

minutes the flame size has reduced.

Turn off the control knob and check that

the oven flames go out.

into

the

grill