Directed DIRECTECHS HK14 설치 매뉴얼 - 페이지 12

{카테고리_이름} Directed DIRECTECHS HK14에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed DIRECTECHS HK14 19 페이지.

Module programming

Refer to "LED diagnostics and troubleshooting" on page 13 for more information and for troubleshooting purposes.

To connect the module:

Please ensure that the vehicle is in a safe location and cannot move forward during

programming. For vehicles equipped with a manual transmission, make sure the gearshift

lever is in the neutral position.

Connect all the harnesses to the Directed Digital Solutions, EXCEPT the 12-pin main power

harness.

Connect the 12-pin main power harness, and wait until the LED turns ON solid red.

Note: To skip the transponder programming and use convenience features only, press

the programming button 5 times. When the LED turns ON solid orange, proceed to

step 4.

Insert and turn the key to the Ignition position. The LED flashes orange, then solid green for

3 seconds.

Note: If the transponder programming was skipped, the LED turns ON solid orange for

3 seconds, then turns OFF when programming is completed.

Turn the key to OFF and remove it from the ignition barrel, once the module is

successfully programmed.

Pair remotes (if applicable). For information on how to pair a specific remote, please

refer to its corresponding owner documentation, which can be found inside the product

packaging of the complete system or on www.directechs.com.*

DATA Tach: Firmware using DATA Tach, the tachometer is preprogrammed for the vehicle

and no further action is required. For instructions on how to adjust tach or use Virtual tach,

see page 16 (not needed with hardwired or data tach applications).

Hardwired Tach: Firmware using the Violet/White Hardwire Tach input will require

programming. For instructions on how to program or adjust tach or use Virtual tach, see

page 16 (not needed with hardwired or data tach applications).

* Your aftermarket remote may differ from the model shown in the illustrations.

You have successfully completed the module programming sequence.

Connect all but the

12-pin harness

Must be connected LAST

Key IN

Solid

Flashes

x 3 Secs

Key OUT

Pair

remotes*

Initialize

tachometer

Directed Digital Solutions HK14

Solid

Key IN

START