Directed DIRECTECHS HK14 Посібник з монтажу - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільна електроніка Directed DIRECTECHS HK14. Directed DIRECTECHS HK14 19 сторінок.
Друкувати сторінкуModule programming
Refer to "LED diagnostics and troubleshooting" on page 13 for more information and for troubleshooting purposes.
To connect the module:
Please ensure that the vehicle is in a safe location and cannot move forward during
1
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
Connect all the harnesses to the Directed Digital Solutions, EXCEPT the 12-pin main power
2
harness.
Connect the 12-pin main power harness, and wait until the LED turns ON solid red.
3
Note: To skip the transponder programming and use convenience features only, press
the programming button 5 times. When the LED turns ON solid orange, proceed to
step 4.
Insert and turn the key to the Ignition position. The LED flashes orange, then solid green for
3 seconds.
4
Note: If the transponder programming was skipped, the LED turns ON solid orange for
3 seconds, then turns OFF when programming is completed.
Turn the key to OFF and remove it from the ignition barrel, once the module is
5
successfully programmed.
Pair remotes (if applicable). For information on how to pair a specific remote, please
6
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
DATA Tach: Firmware using DATA Tach, the tachometer is preprogrammed for the vehicle
and no further action is required. For instructions on how to adjust tach or use Virtual tach,
see page 16 (not needed with hardwired or data tach applications).
7
Hardwired Tach: Firmware using the Violet/White Hardwire Tach input will require
programming. For instructions on how to program or adjust tach or use Virtual tach, see
page 16 (not needed with hardwired or data tach applications).
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
12
Connect all but the
12-pin harness
Must be connected LAST
&
Key IN
ON
Solid
Flashes
x 3 Secs
Key OUT
Pair
remotes*
Initialize
tachometer
Directed Digital Solutions HK14
© 2019-11-15 Directed. All rights reserved.
Solid
Key IN
START