Clarke CFP9HND 운영 및 유지 관리 지침 - 페이지 12
{카테고리_이름} Clarke CFP9HND에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CFP9HND 20 페이지.
페이지 인쇄
TROUBLE SHOOTING CHART
IMPORTANT
1. Any remedial work that may be required must be carried out by a qualified engineer.
2. Switch off the engine before removing any parts from the compressor.
3. Drain the Air Receiver before dismantling any part of the compressor unit's pressure system.
4. If your compressor develops a fault do not use until the fault has been rectified.
5. For troubleshooting the engine, refer to the engine manual.
SYMPTOM
Engine difficult to
start
Compressor unit
constantly 'on load'
Compressor
constantly 'on load'
and cannot attain
the working pressure
required.
PROBABLE CAUSE
Load Genie leaking
(compressor unit is on load
during start).
Load Genie valve blocked,
possibly frozen up.
Load Genie defective.
Load Genie set at a pressure
higher than the safety
valve's opening pressure.
Load Genie leaking.
Suction filter blocked.
Leak between compressor
block and air receiver leaks in
or near air receiver.
Valves blocked by dirt, paint,
dust or choked up.
Inspection cover or drain plug
leaking.
Pressure gauge defective.
Unit too small in relation to
air consumption.
Compressor worn.
Stop engine and empty air
receiver. Clean or replace
Load Genie
Thaw Load Genie out (Unit must
be installed in frost-free place).
Have Load Genie serviced or
replaced
Contact Clarke Service
Department
Contact Clarke Service
Department
Clean / Change filter.
Tighten connection and
repair leak.
Contact Clarke Service
Department
Empty air receiver and
change seals/plugs.
Change pressure gauge.
Use a larger capacity
compressor
Have compressor overhauled or
replace it.
- 12-
REMEDY