Directed Viper 220 MAX 설치 매뉴얼 - 페이지 9

{카테고리_이름} Directed Viper 220 MAX에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Viper 220 MAX 18 페이지. Recreational vehicle security system

Wiring an optional 508D perimeter sensor

For additonnal protection, a 508D perimeter microwave sensor can be added to the security system. When

installed with one of Directed Electronics security system could be interfaced with the shock sensor harness. The

508D has a dual stage trigger output, that will either Warn or trigger the security system, both wires the blue

and the green are Multiplex. Blue wire will report on zone 2 and Green wire will report on zone 4.

IMPORTANT ! Make sure that all openings on the perimeter sensor are sealed, using

sillicone and that you apply a layer of grease on the contacts. These procedures will

prevent water infiltration which may damage internal circuits of the digital Tilt/Motion

sensor.

Transmitter configuration

473T TRANSMITTER

The security system comes with One 3-button transmitters that have been taught to the receiver. When using

the automatic learn routine described on the next page you will get the 3-button transmitter standard configu-

ration as follow:

Button

operates the arm and disarm.

Button

is useed to control the Silent Mode®.

Button

is useed to control the Panic Mode when pressed for more than 1.5 seconds.