Clarke PPH10ND 운영 및 유지 관리 지침 - 페이지 14

{카테고리_이름} Clarke PPH10ND에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke PPH10ND 17 페이지. Air compressor
Clarke PPH10ND에 대해서도 마찬가지입니다: 운영 및 유지보수 매뉴얼 (10 페이지), 운영 및 유지 관리 지침 (20 페이지)

페이지 인쇄

TROUBLE SHOOTING CHART

IMPORTANT

1. Any remedial work that may be required must be carried out by a qualified engineer.

2. Switch off the engine before removing any parts from the compressor.

3. Drain the Air Receiver before dismantling any part of the compressor unit's pressure system.

4. If your compressor develops a fault do not use until the fault has been rectified.

5. For troubleshooting the engine, refer to the engine manual.

SYMPTOM

Engine difficult to

Load Genie leaking

start

(compressor unit is on load

during start).

Non-return valve blocked,

possibly frozen up.

Compressor unit

Load Genie defective.

constantly 'on load'

Load Genie set at a pressure

higher than the safety

valve's opening pressure.

Load Genie leaking.

Compressor constantly

'on load' and cannot

attain the working

pressure required.

Compressor worn.

PROBABLE

Suction filter blocked.

Leak between compressor

block and air receiver leaks in

or near air receiver.

Valves blocked by dirt, paint,

dust or choked up.

Inspection cover or drain plug

leaking.

Pressure gauge defective.

Unit too small in relation to

air consumption.

- 15 -

REMEDY

Stop engine and empty air

receiver. Clean or replace

Load Genie

Thaw Load Genie out (Unit must

be installed in frost-free place).

Have Load Genie serviced or

replaced

Adjust Load Genie

WARNING: DO NOT ADJUST

LOAD GENIE ABOVE MAXIMUM

WORKING PRESSURE DETAILED.

Change filter.

Tighten connection and

repair leak.

Clean or change valves.

Empty air receiver and

change seals/plugs.

Change pressure gauge.

Use a larger capacity

compressor

Have compressor overhauled or

replace it.