Clarke PPH10ND 운영 및 유지 관리 지침 - 페이지 16
{카테고리_이름} Clarke PPH10ND에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke PPH10ND 17 페이지. Air compressor
Clarke PPH10ND에 대해서도 마찬가지입니다: 운영 및 유지보수 매뉴얼 (10 페이지), 운영 및 유지 관리 지침 (20 페이지)
페이지 인쇄
Compressor unit runs
Large amount of condensation in
on and off load more
air receiver.
frequently than usual.
Leaks in system
Compressor unit runs
Leaks in system.
'on load' when no air is
being used.
Compressor's oil
Too much oil in compressor.
consumption rising.
Leaks around crank case.
Working temperature of
compressor too high because of
insufficient cooling.
Cylinder worn.
Intake air filter blocked.
Oil in the air delivered.
Sump over full.
Cylinder worn.
Intake air filter blocked.
Oil level rises although
Condensation in oil pump.
no oil has been put in.
Condensation at outlet
Piping installation incorrect.
points.
Compressor taking in air which is
too warm.
Drain off condensation Regularly
(Every day before use).
Locate leaks (by means of soapy
water) and repair.
Locate leaks (by means of
soapy water) and repair.
Check oil level 2 or 3 minutes after
stopping.
Change seal and inspect
packing surfaces. Repair or
replace defective parts.
Increase ventilation to air
compressor.
Replace worn parts or send
compressor pump for an
overhaul.
Reduce oil to correct level.
Replace worn parts or send
compressor pump for an
overhaul.
Change air filter.
Compressor over dimensioned.
Consult your local dealer.
Obtain better fresh-air supply to
compressor.
- 17 -