Directed XpressKit DBALL 설치 매뉴얼 - 페이지 11
{카테고리_이름} Directed XpressKit DBALL에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed XpressKit DBALL 16 페이지. Ford5 remote start ready (rsr) installation
Directed XpressKit DBALL에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지)
페이지 인쇄
Platform: DBALL/DBALL2
Firmware: CHRYSLER7 Range Extender Ready (RXT) Installation
LED
Description
External module synchronization
Diagnostic OBDII feature not
initialized.
(Flashes red, red,
then orange) x 10
D2D and W2W commands
Flashes orange
LOCK command received.
x 1
Flashes orange
UNLOCK command
x 2
received.
Flashes orange
TRUNK command received.
x 3
LED
Description
RXT Code
Flashes green
Start command received.
x7
Flashes green
Stop command received.
x8
Flashes red x 5
Start failed.
Flashes red x 6
Stop failed.
Flashes red x 7
RFTD disabled.
Flashes red x 8
OEM RS disabled.
Troubleshooting
Diagnostic OBDII BUS statuses like DTC codes
w ill not be available on SmartStart because the
BUS w as not detected. Please check your
HSCAN connections, reset, and reprogram the
module.
If the bypass module fails to flash, it means the
module did not receive the signal.
Troubleshooting
If the bypass module fails to flash, it means the
module did not receive the signal.
RXT start command not executed.
OEM Remote Start Activation w as attempted
w hen RFTD feature is disabled.
RXT start not possible w hen OEM system is
disabled.
Comment
SmartStart can still be used but w ill w ork w ith limited
statuses.
Commands can come from RF, D2D or W2W.
Comment
If using XL202, make sure that the proper cable is
connected. When using SmartStart make sure that
SmartStart is configured in D2D.
Module received the command, but the car did not
perform the action.
Activated from Web automatically w hen using RXT
flash tool or can be done manually. Refer to feature
programming section for more information.
Refer to the ow ner documentation to activate it.
© 2014 Directed. All rights reserved.
Rev.: 20141117
Page 11