Directed XpressKit DBALL 설치 매뉴얼 - 페이지 3

{카테고리_이름} Directed XpressKit DBALL에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed XpressKit DBALL 16 페이지. Ford5 remote start ready (rsr) installation
Directed XpressKit DBALL에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지)

페이지 인쇄

1. Vehicle Application Guide

Platform: DBALL/DBALL2

Firmware: CHRYSLER7 Range Extender Ready (RXT) Installation

Installation without T-Harness

OBDII

Diagnostic Connector

HS CAN High: Gray/White, pin 6

(-) Ground: Black, pin 4

HS CAN Low:

Yellow,

pin 14

BCM

under driver dash

(C5 connector)

1 2 3

5 6 7

9 10 11 12 13 14 15

17 18 19 20 21 22 23 24 25 26 27 28 29

Fuse 20A

(+) 12V

87a

EIPS Feature: Do not connect these wires if you don't want to activate this feature.

[1]

With the exception of the OBDII Diagnostic connector, all connectors are displayed from the wire side.

(+) 12V: Red, pin 16

31 32

Horn: Gray/Black, pin 30

HS CAN High: Tan/Black: 3

HS CAN Low: Tan: 4

(+) 12V: Red: 13

(-) Ground: Black: 14

(-) EIPS Fail Output: Blue/Red: 12

[1]

DBALL/

Prog. Button

DBALL2

LED

You can connect to either a XL202

RFTD OR a SmartStart module.

Refer to the SmartStart/XL202

Installation Notes for more information.

Rev.: 20141117

Page 3