Directed XpressKit DBALL Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для По замкам Directed XpressKit DBALL. Directed XpressKit DBALL 16 страниц. Ford5 remote start ready (rsr) installation
Также для Directed XpressKit DBALL: Руководство (14 страниц), Руководство по установке (16 страниц), Руководство (19 страниц)
Печатать страницу
Platform: DBALL/DBALL2
Firmware: CHRYSLER7 Range Extender Ready (RXT) Installation
Installation without T-Harness
OBDII
Diagnostic Connector
HS CAN High: Gray/White, pin 6
(-) Ground: Black, pin 4
1
9
HS CAN Low:
Yellow,
pin 14
BCM
under driver dash
(C5 connector)
1 2 3
4
5 6 7
8
9 10 11 12 13 14 15
17 18 19 20 21 22 23 24 25 26 27 28 29
87
Fuse 20A
86
(+) 12V
87a
EIPS Feature: Do not connect these wires if you don't want to activate this feature.
[1]
With the exception of the OBDII Diagnostic connector, all connectors are displayed from the wire side.
8
16
(+) 12V: Red, pin 16
16
30
31 32
Horn: Gray/Black, pin 30
85
30
HS CAN High: Tan/Black: 3
HS CAN Low: Tan: 4
(+) 12V: Red: 13
(-) Ground: Black: 14
(-) EIPS Fail Output: Blue/Red: 12
[1]
RF
DBALL/
Prog. Button
DBALL2
LED
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2014 Directed. All rights reserved.
Rev.: 20141117
Page 3