Directed XpressKit DBALL 설치 매뉴얼 - 페이지 12

{카테고리_이름} Directed XpressKit DBALL에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed XpressKit DBALL 16 페이지. Ford5 remote start ready (rsr) installation
Directed XpressKit DBALL에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 매뉴얼 (14 페이지), 매뉴얼 (19 페이지)

페이지 인쇄
Directed XpressKit DBALL 설치 매뉴얼
Platform: DBALL2
Firmware:
CHRYSLER4

Feature Programming

To enter feature programming routine
-
Turn t
he ignition
ON
, then
-
Within 5 seconds, press and
Programming button.
-
The
LED
will flash green once slowly
the current option of feature 1
repeat until
a new command is entered
Changing feature options
-
Press the
lock/
arm or
unlock/
-
The
LED
flashes
red
rapidly the number of times equal to the current option number. After a short delay, the
slowly the number of times to indicate the current feature.
Accessing another feature
-
Press and release the programming button a number of times to advance from the current feature to the next desired feature.
-
The
LED
flashes green slowly the number of times equal to the feature number. After a short delay, the
indicate the current option of the current feature.
When the maximum number of features or options is reached, the
option.
Once a feature is programmed
-
Other features can be programmed.
-
The feature programming can be exited.
Exiting feature programming
-
No activity for 30 seconds; after 30 seconds, the
sequence.
OR
-
Press and
HOLD
the programming button for 3 seconds. After 3 seconds, the
the end of the programming sequence.
OFF
.
HOLD
the rogramming button
p
to indicate the feature number is 1. After a short delay, the
(i.e. 1x green followed by 1x red indicates feature 1 is set to option 1) The flashing sequence will
.
disarm button on aftermarket transmitter to change the option of the selected feature.
The flashing sequence will
LED
will turn
until the
LED
turns
ON
orange (
The flashing sequence will
repeat until
repeat until
a new command is entered
LED
will start flashing again from the first feature or
ON
orange for 2 seconds to confirm the end of the programming
LED
will turn
Programming
Button
after 3 seconds . Release the
)
LED
flashes
red
rapidly to indicate
.
LED
flashes green
a new command is entered
LED
flashes red rapidly to
.
ON
orange for 2 seconds to confirm
© 2017 Directed. All rights reserved.
Rev.: 20170818
Page 12
.