Directed XpressKit DBALL Kurulum Kılavuzu - Sayfa 12
Kilitler tarafından Directed XpressKit DBALL için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed XpressKit DBALL 16 sayfaları. Ford5 remote start ready (rsr) installation
Ayrıca Directed XpressKit DBALL için: Kurulum Kılavuzu (16 sayfalar), Manuel (14 sayfalar), Manuel (19 sayfalar)
Sayfayı Yazdır
Platform: DBALL2
Firmware:
CHRYSLER4
Feature Programming
To enter feature programming routine
-
Turn t
he ignition
ON
, then
-
Within 5 seconds, press and
Programming button.
-
The
LED
will flash green once slowly
the current option of feature 1
repeat until
a new command is entered
Changing feature options
-
Press the
lock/
arm or
unlock/
-
The
LED
flashes
red
rapidly the number of times equal to the current option number. After a short delay, the
slowly the number of times to indicate the current feature.
Accessing another feature
-
Press and release the programming button a number of times to advance from the current feature to the next desired feature.
-
The
LED
flashes green slowly the number of times equal to the feature number. After a short delay, the
indicate the current option of the current feature.
When the maximum number of features or options is reached, the
option.
Once a feature is programmed
-
Other features can be programmed.
-
The feature programming can be exited.
Exiting feature programming
-
No activity for 30 seconds; after 30 seconds, the
sequence.
OR
-
Press and
HOLD
the programming button for 3 seconds. After 3 seconds, the
the end of the programming sequence.
OFF
.
HOLD
the rogramming button
p
to indicate the feature number is 1. After a short delay, the
(i.e. 1x green followed by 1x red indicates feature 1 is set to option 1) The flashing sequence will
.
disarm button on aftermarket transmitter to change the option of the selected feature.
The flashing sequence will
LED
will turn
until the
LED
turns
ON
orange (
The flashing sequence will
repeat until
repeat until
a new command is entered
LED
will start flashing again from the first feature or
ON
orange for 2 seconds to confirm the end of the programming
LED
will turn
Programming
Button
after 3 seconds . Release the
)
LED
flashes
red
rapidly to indicate
.
LED
flashes green
a new command is entered
LED
flashes red rapidly to
.
ON
orange for 2 seconds to confirm
© 2017 Directed. All rights reserved.
Rev.: 20170818
Page 12
.