Blackberry Radar H2 설치 매뉴얼 - 페이지 25

{카테고리_이름} Blackberry Radar H2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry Radar H2 30 페이지. Dry van, insulated trailers roll-up doors
Blackberry Radar H2에 대해서도 마찬가지입니다: 설치 매뉴얼 (33 페이지), 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (25 페이지), 설치 매뉴얼 (32 페이지), 설치 매뉴얼 (33 페이지), 설치 매뉴얼 (34 페이지), 설치 매뉴얼 (35 페이지), 사용 설명서 (33 페이지), 설치 매뉴얼 (32 페이지), 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (25 페이지), 설치 매뉴얼 (28 페이지)

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE 25

3.4.4 Cargo van installation procedure (doors with windows)

As mentioned in Section 3.4.3, if you wish to monitor door open/close events with

your BlackBerry Radar-L module, you will need to mount it on the door. If your van

has windows, and you don't have adequate space above the window to mount the

module, you will need to mount it lower on the door. In this section, we will discuss

recommended installation tools and procedures for this scenario

As you consider the best placement on your asset, please consider the following:

For vans with double doors, the module should be placed on the door with the latch

•

and as close to the inside edge of this door as the door construction allows.

Mounting the module on the door with the latch will ensure all door open/close

events are registered--even in instances where only one door is opened.

Often, when the module must be placed below the window, you will encounter a

•

"blind" mounting situation where the thickness of the door prevents you from

installing nuts on the rear of the bolts. On many vehicles, the sheet metal is too thin

to support secure mounting with self-tapping screws. Frequent removal and re-

installation of these fasteners to replace the battery module or exchange modules,

can also enlarge the hole, further making the attachment less secure. To allow for

most secure device mounting in these instances, a threaded insert (i.e., well nuts)

are recommended for use with the selected mounting bolts.