Blackberry Radar H2 설치 매뉴얼 - 페이지 11

{카테고리_이름} Blackberry Radar H2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry Radar H2 28 페이지. Dry van, insulated trailers roll-up doors
Blackberry Radar H2에 대해서도 마찬가지입니다: 설치 매뉴얼 (33 페이지), 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (25 페이지), 설치 매뉴얼 (32 페이지), 설치 매뉴얼 (30 페이지), 설치 매뉴얼 (33 페이지), 설치 매뉴얼 (34 페이지), 설치 매뉴얼 (35 페이지), 사용 설명서 (33 페이지), 설치 매뉴얼 (32 페이지), 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (25 페이지)

BLACKBERRY RADAR H2 ITC100-1, ITC100-2, ITF100-1 INSTALLATION GUIDE

3.4.1 Prepare module for installation—Battery connection

IMPORTANT: Please do not perform the battery connection process until you are

ready to install and associate the BlackBerry Radar modules on your asset. Once

the battery is connected, please complete the module installation and association,

as soon as you can, to conserve battery life.

1. Remove the module from the package and from the plastic bag. Detach the fastener bag

from the end of the module and keep nearby. You will require these screws to complete

the module assembly process.

2. Turning the module bottom side up, grasp the end of the module's inner housing. Pull to

separate the inner housing from the outer housing.

Tip: If you find it difficult to remove the inner housing from the outer housing, you may

insert a tool, such as a screwdriver or long bolt, through the hole in the inner housing.

Grasp the tool and the outer housing, then pull the two housings apart.

FLATBED AND HEAVY EQUIPMENT