Blackberry RADAR H2 ITC100-1 설치 매뉴얼
{카테고리_이름} Blackberry RADAR H2 ITC100-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry RADAR H2 ITC100-1 30 페이지. Magnet accessory
Blackberry RADAR H2 ITC100-1에 대해서도 마찬가지입니다: 설치 매뉴얼 (33 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (35 페이지), 설치 매뉴얼 (25 페이지), 설치 매뉴얼 (35 페이지)
페이지 인쇄
BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE 31
It is recommended that you install the module as level as possible on the asset. To
help ensure the device is level, you may try one of the following techniques.
Technique 1: Position the T-square along the edge of the door. Using the T-square
as a guide, draw a horizontal line approximately 5" (13 cm) in length, in the area you
plan to install the device, with your pencil or marker. Align the bottom edge of the
template to the line.
Tip: To avoid leaving a permanent mark on your trailer or container after the device
installation is complete, we recommend using a pencil or non-permanent marker to
create the guideline.
Technique 2: Visually, place the template in the desired installation location. Using
a level, check that the template is level.