Blackberry RADAR H2 ITC100-1 설치 매뉴얼 - 페이지 6

{카테고리_이름} Blackberry RADAR H2 ITC100-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry RADAR H2 ITC100-1 30 페이지. Magnet accessory
Blackberry RADAR H2 ITC100-1에 대해서도 마찬가지입니다: 설치 매뉴얼 (33 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (35 페이지), 설치 매뉴얼 (25 페이지), 설치 매뉴얼 (35 페이지)

페이지 인쇄

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE

2. Evaluate the amount of clearance you will have once your module is installed. This

will help you determine the best mounting location for your asset. You can perform a

clearance check, prior to drilling any mounting holes in your door, by securing the

module to the door with tape and moving the door through its complete range of

travel, to ensure there is no interference.

Tips for roll-up door installation

Tip 1: If you have tried a higher mounting position, and found you did not

have enough clearance to allow uninterrupted door travel, try moving the

module lower on the door. Lower door placements can help address some

clearance issues by reducing the distance the module has to travel inside the

trailer, past potential interference points.

Tip 2: When determining your preferred mounting location, consider the

climate conditions your asset may encounter. For example, if you routinely

run your vehicle in very cold climates, where ice accumulation on the rear of

the trailer is an issue, you will want to consider the typical ice accumulation

thickness your asset may see when determining how much clearance is

acceptable. Also consider your ability to remove such accumulations should

they occur.