Blackberry RADAR H2 ITC100-1 설치 매뉴얼 - 페이지 8
{카테고리_이름} Blackberry RADAR H2 ITC100-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry RADAR H2 ITC100-1 30 페이지. Magnet accessory
Blackberry RADAR H2 ITC100-1에 대해서도 마찬가지입니다: 설치 매뉴얼 (33 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (35 페이지), 설치 매뉴얼 (25 페이지), 설치 매뉴얼 (35 페이지)
페이지 인쇄
38
BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE
5. Using a drill bit, drill a hole through each of the cross hairs on the template. This will
create four holes you will use to mount the module.
Drilling tips for one person installation on a roll-up door
If you are installing the module high on the door-- and have selected nuts,
bolts, and washers as your fasteners -- you will need to install the bolt from
the exterior side, then enter the trailer to install the nut from the interior side.
To help keep the device in place, while allowing a single installer to open the
door and enter the trailer to install the nut, you may wish to:
Drill a hole one size below your fastener diameter.
•
Use a drill and nut driver to drive the bolt through the door. This will
•
allow the threads to hold the device in place while you open the door.
Enter the trailer and install the nut and washer to the rear of the bolt.
•