Blackberry RADAR H2 ITC100-1 Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Radar Blackberry RADAR H2 ITC100-1. Blackberry RADAR H2 ITC100-1 30 stron. Magnet accessory
Również dla Blackberry RADAR H2 ITC100-1: Instrukcja instalacji (33 strony), Instrukcja instalacji (28 strony), Instrukcja instalacji (35 strony), Instrukcja instalacji (25 strony), Instrukcja instalacji (35 strony)

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE

5. Using a drill bit, drill a hole through each of the cross hairs on the template. This will

create four holes you will use to mount the module.

Drilling tips for one person installation on a roll-up door

If you are installing the module high on the door-- and have selected nuts,

bolts, and washers as your fasteners -- you will need to install the bolt from

the exterior side, then enter the trailer to install the nut from the interior side.

To help keep the device in place, while allowing a single installer to open the

door and enter the trailer to install the nut, you may wish to:

Drill a hole one size below your fastener diameter.

•

Use a drill and nut driver to drive the bolt through the door. This will

•

allow the threads to hold the device in place while you open the door.

Enter the trailer and install the nut and washer to the rear of the bolt.

•