Directed Xpresskit DBALL2 설치 매뉴얼 - 페이지 14

{카테고리_이름} Directed Xpresskit DBALL2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Xpresskit DBALL2 16 페이지. Ford5 remote start ready (rsr) installation
Directed Xpresskit DBALL2에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (18 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (15 페이지), 설치 및 빠른 참조 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지)

페이지 인쇄

Quick Reference Guide

DBALL2-CHYRSLER8 Remote Start Ready (RSR) Installation

Vehicle Takeover

Press the remote start button on the transmitter to

start the vehicle.*

Press the Unlock button on the factory

or aftermarket remote.*

Enter the vehicle.

Insert the key into the ignition barrel and

turn the key to the ON position.

Press the brake pedal, put the car

in gear and drive off.

* Your aftermarket remote may differ from the model shown in the illustrations.

Press

remote start

button*

Press Unlock

button on

either remote*

Enter vehicle

Key IN

START

Ready to

drive off

Pit Stop Mode

The Pit Stop Mode feature is practical when you need to stop and run an errand,

but wish to keep the engine running.

Stop the vehicle in a safe parking spot

and put the gear in Park (P).

Press the button to remote start the vehicle.*

Remove the key from ignition.

It is now safe to leave the engine running and exit the

vehicle with the factory remote in hand.

Note: We recommend that you always lock the doors

of your vehicle when leaving it unattended.

* Your aftermarket remote may differ from the model shown in the illustrations.

Parking Light Error Codes

The parking lights on your vehicle will flash a specific number of times 3 seconds

following an unscheduled shutdown or failure to start. Each flashing pattern is

described below.

Flashes

Diagnostic

Runtime expired.

Over-rev shutdown.

Low/No RPM.

Transmitter shutdown.

Brake shutdown.

Hood shutdown/Remote start safety override switch is ON*.

Remote start safety override switch is ON*.

* If the vehicle hood status is supported through data, safety override switch input

will report 7 flashes.

Stop & put vehicle in Park (P)

Press

remote start

button*