Directed Xpresskit DBALL2 설치 매뉴얼 - 페이지 3

{카테고리_이름} Directed Xpresskit DBALL2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Xpresskit DBALL2 16 페이지. Ford5 remote start ready (rsr) installation
Directed Xpresskit DBALL2에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (18 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (15 페이지), 설치 및 빠른 참조 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지)

페이지 인쇄

Platform: DBALL2

Firmware:

CHRYSLER8 Remote Start Ready (RSR) Installation

Installation without T-Harness

C2 2-pin Blue conn.

(located at BCM,

under driver side dash)

(+) 12V:

Red, pin A

Immo. Data (veh. side): Orange/Yellow: 9

(MUX) Parking Light Output: Violet/Brown: 9

Immo. Data (veh.side): Yellow/Black: 10

Immo. Data:

White/Lt Green: pin 5

Ignition Node

(black connector)

Not required in D2D mode.

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

Required for RAP, heated seats, steering wheel and rear defroster control.

[2]

With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).

Diagnostic Connector

IHS CAN High: Gray, pin 3

[2]

IHS CAN Low

[2]

White, pin 11

Yellow, pin 14

CAN C High: Tan/Black: 3

CAN C Low: Tan: 4

IHS CAN2 High: Orange/Green: 5

[2]

IHS CAN2 Low: Orange/Brown: 6

[2]

Immo. Data (conn. side): Yellow: 8

(+) 12V: Red: 13

(-) Ground: Black: 14

(MUX) Parking Light: White/Brown, pin 1

2 3 4

Black conn.

(Located at Parking

Light Switch)

C4 60-pin Black conn.

(located at BCM,

under driver side dash)

OBDII

CAN C High: Gray/White, pin 6

CAN C Low:

Prog.Button

DBALL2

LED

You can connect to either a XL202

RFTD OR a SmartStart module.

Refer to the SmartStart/XL202

Installation Notes for more information.

(-) Hood:

Violet/Lt.Blue, pin 8

Remote Start Safety

Override Switch

6: White/Black: (-) Hood

Rev.: 20151126

Page 3