Blackberry RADAR-M ITA100-1 설치 매뉴얼 - 페이지 11
{카테고리_이름} Blackberry RADAR-M ITA100-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry RADAR-M ITA100-1 39 페이지. Container, dry van, insulated trailers barn doors
Blackberry RADAR-M ITA100-1에 대해서도 마찬가지입니다: 설치 매뉴얼 (27 페이지), 설치 매뉴얼 (36 페이지)
페이지 인쇄
BLACKBERRY RADAR ITA100-1 CHASSIS BRACKET INSTALLATION GUIDE 11
To attach the bracket to the equipment you wish to track, you will need to supply four
fasteners. Depending on the construction of your mounting location, you may wish to use
the following types of fasteners. Please Note: Your choice of fastener will influence the
size of the tools required to create the mounting holes (drill bits) and install or remove the
fasteners (i.e. wrenches/sockets/drivers). An example is provided below.
Box Section
I-Beam or Panel Section
3.2 Installation Tools
Required tools to complete the installation:
Allen Key (5 mm) or
Torx Bit (T-30)
*Torx Bit + Drill offers fastest installation.
If no Torx Bit is available, an Allen Key may
be used as a substitute.
Nut Driver or
Socket Wrench with Socket*
*Nut Driver + Drill offers fastest installation.
If no Nut Driver is available, a socket wrench
and socket may be used as a substitute.
4 self-tapping screws and washers
(10 mm head, M6 thread, 25mm length)
4 bolts, nuts, and washers
(11mm head, M6 thread, 25mm length, M6 nut)
Drill and drill bits
Safety Glasses
Drill Bit
3/16" (5mm)
Nut Driver/Socket/Wrench
Drill Bit
1/4" (6mm)
Nut Driver/Socket/Wrench
Cutting Lubricant*
(Recommended)
*Recommended for faster drilling speed
on thicker metals and longer drill bit life.
Large Screwdriver
(Flathead)
Wrench
*Required only if nuts and bolts are used.