Blackberry RADAR-M ITA100-1 설치 매뉴얼 - 페이지 12
{카테고리_이름} Blackberry RADAR-M ITA100-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry RADAR-M ITA100-1 39 페이지. Container, dry van, insulated trailers barn doors
Blackberry RADAR-M ITA100-1에 대해서도 마찬가지입니다: 설치 매뉴얼 (27 페이지), 설치 매뉴얼 (36 페이지)
페이지 인쇄
12
BLACKBERRY RADAR ITA100-1 CHASSIS BRACKET INSTALLATION GUIDE
3.3 Matching a module identifier to an asset identifier
In order to track an asset (trailer/container), the Radar module that is installed on the asset
must be associated with the asset in the BlackBerry Radar Dashboard. It is, therefore, very
important to keep a clear record of which Radar module is installed on which asset.
The Dashboard application tracks modules and assets using 'identifiers'. The asset
identifiers are entered into the application when you add the assets, and are listed on your
installation worksheet. The identifier for each Radar device is printed on two labels
attached to the back of the external module. The module identifier also serves as the serial
number (S/N) for the device.
To match a module identifier with an asset identifier:
1. Locate the module identifier for your device. The module identifier is printed on two
labels attached to the back of the external module.
External Module
2. Remove the partially attached label from the rear of the external module and place it
on the outer surface of the external module. Following this approach will allow you to
easily identify the module after it's assembled to the bracket. This is especially
helpful if you are assembling a group of modules to brackets, prior to installing them
on assets.